evrithing is OK but no quality, check my work

[Vlad]

I'm living in Indy this will be 39.77640 N , 86.14619 W.
My motor elevation will be 44 azimuth will be 180 +1 = 181.
My dish elevation will be 24.
Now everything is set. I have chanel master satelite dish signal finder.
The first satelite what I find /I think is AMC3/ is just about 1 degree on west. The satelite finder show me high level, I move the dish up/down to check if need more ajustment but this is the only fine position.
When I look at satelite receiver there is just 40% /higest/ level and 0% quality. I move the dish very, very slowly on west this satelytr is gone but coming another one, and still nothing. I tryed whit all list of frequency but still dont have the signal.
The LNB is from dish network but and I put the standart on receiver.
Before I install the sattelyte dishes but I never don't have problem like this.
What you think is the receiver has any problems or LNB is defective. The receiver is Fortec lifetime, the LNB is DVB 322 dual. I received LNB not in box and I think Sadoun send me used one.
I has LNB from directv but not shure how is working with this system.


Vlad

[Sadoun]

VLAD

The LNBF you got is not a used one. It came without box because we buy it in bulk. This is a STANDARD type LNBF so make sure you change the LNB type to STANDARD and LO Freq to 10750 for all satellites in your receiver.

Since you are installing a motorized system, it is much more challenging to install than a Dish Network or DirecTV system.

From your description above, it looks like you setup the motor to the wrong elevation. It should be equal to your latitude (~ 40) and not 44 as you have indicated.

Read the following instructions carefully: http://sadoun.com/Sat/Installation/H...stallation.htm

[Vlad]

Finally I founded what I'm doing wrong. Sadoun You help me to much , Thank you, just the LO LNB I was enteret the frequency on satelite program, when I changed to 10750 everything was fix.

THANK YOU again