I use TSReader exclusively. Full version will let you stream the content for more than a minute (I believe that is the restriction of the lite version).
What are your thoughts as far as using the card as a positioner? I think I saw another moderator say it would work with a good PC power supply.
Presently, I use my "Ultra" as a positioner-scanner & loop out to a QualiTV 1080IR.
Last night, after positioning the dish to AMC 3 with the Ultra, I powered down everything..... connected the coax from the dish directly to the 102G, booted the pc. The LNB power was "OFF", I set dish type to "Fixed" and immediately locked a TP. There should have been no power to the LNB. I don't get it. Checked my settings over and over again. The power had to come from the PC. I can work around this with no problem. Just wondering if you, or anyone else has seen this before?
I really can'tsaymuch about it. I have used the card twice as a positioer and it worked fine. I used Fortec Ultra for positioning anmd my card i slaved of of it.
Can you help me with input setup settings? When I try to tune PBS on AMC 3, I am getting "failed to Lock". But if I exit, and open WinDVB, it tunes and locks.
I am using a Universal LNBf and I selected Twinhan 102G as my source during install.....
My input setup are:
D1, Auto select LNB between 0 .... 0 (unchecked)
LNB Type is "MultiBand" Low 9750 Hi 10600
switch freq is 0
voltage is set to "polarity"
tone is "off"
Linear Mode
