AMC4

ky03 · #1 (**permalink**) 03-04-2004, 12:05 AM

What is the LO,Hi set up forAmc4 on my BEC2000 so i can find the signal,i already found T5,i need Amc 4.Thanks for any help.

DruzeTito · #2 (**permalink**) 03-04-2004, 01:32 AM

LO settings do not depend on the satellite you are viewing but the LNB you are using. Make sure you have a linear LNB for AMC 4 (you problably do if you can see T5) and make sure you are using an active transponder for AMC 4 (http://www.lyngsat.com/amc4.shtml) to view the signal/quality strength.

dtsexpert · #3 (**permalink**) 03-04-2004, 01:33 AM

Linear Ku. Same as T5.
Universal lnbf : low 9750, high 10600
Standar: 10750
Michael

Quote:

Originally Posted by ky03

What is the LO,Hi set up forAmc4 on my BEC2000 so i can find the signal,i already found T5,i need Amc 4.Thanks for any help.

ky03 · #4 (**permalink**) 03-04-2004, 11:37 AM

Thank you ,but what is wrong i have only total 8 TP when i scan 1 sat at AMC 4 But i think they scamble channels.i think it should have more than 8 TP ,need some HELP with the set up of BEC 2000 (AMC 4).I have no problem with T5 at all.

BrianC · #5 (**permalink**) 03-04-2004, 11:45 AM

ky03,

Make sure if your using a fixed dish (without motor) that you have the proper tilt of the lnb for that sat. There are some great charts on Sadoun's site.
Your elevation must also be set perfectly.
Also, another tip I'll give you: leave it on one of the TP's that you can receive then go to your dish and very gently move the dish side to side looking for the maximum that you can get that signal. Once you have the highest it will go then try very small adjustments to the elevation both up and down.
When your sure it's at maximum, then go try the other TP's.

Let us know how it works. If you got some your only a tiny movement away.

-Brian