Search:

Tag: assembly

Search: Search took 0.01 seconds.

  1. New LNBF assembly for Dish 500+ (also Dish 1000+)

    Started by SadounSales, 05-29-2012 11:50 PM
    assembly, attach, block, built, color, com, con, config, connect, dish, dish 500, dishnetwork, dpp, ect, lnbf, nec, need, new, plus, products, sadoun, sat, size, switch, work 1 Attachment(s)
    • Replies: 0
    • Views: 461
    Last Post: 05-29-2012 11:50 PM
    by SadounSales  Go to last post

    Forum:
    Dish Network

  2. Looking for six foot polor mount assembly instructions.

    Started by Rob Ram, 01-24-2012 06:00 PM
    assembly, current, dish, drive, etc, file, focus, foot, hard, instructions, its, looking, moun, mount, nuts, older, one, page, pdf, polar, prime, sadoun, showing, six, una, version
    • Replies: 7
    • Views: 917
    Last Post: 01-30-2012 07:21 PM
    by Jim-S  Go to last post

    Forum:
    System Installation

  3. Intelsat 805 help

    Started by boliche, 01-09-2011 10:20 PM
    2 Pages •
    1 2
    actuator, adjusting, angles, antenna, assembly, azimuth, band, declination, dish, distance, don, elevation, feedhorn, focus, footprints, frisky, inferior, intelsat, lnb, mag, moun, mount, org, polar mount, prime, pvr800, satellite, systems, telsat, ten, website
    • Replies: 13
    • Views: 1,458
    Last Post: 01-13-2011 09:07 AM
    by 1captain  Go to last post

    Forum:
    Installation Help Requests

  4. Help!New install..

    Started by dangerous.dan, 07-29-2009 08:06 PM
    110, adjust, align, alignment, arc, assembly, bit, channels, degree, dish, down, elevation, even, first, found, getting, little, need, one, satellite, should, signal, think, west, wrong
    • Replies: 1
    • Views: 530
    Last Post: 08-05-2009 12:57 PM
    by Vitruvius  Go to last post

    Forum:
    Installation Help Requests

  5. Dish Network LNBF Swap

    Started by david7064, 03-16-2009 01:04 PM
    110, 119, arm, assembly, bolt, buy, can, couple, dish, dish network, holes, lnb, lnbf, lnbfs, network, newer, old, place, set, super, swap, work
    • Replies: 1
    • Views: 419
    Last Post: 03-16-2009 03:36 PM
    by Admin  Go to last post

    Forum:
    Installation Help Requests

  6. Help! Where am I? 97W isn't 97W

    Started by cnagorka@gmail.com, 09-18-2008 03:07 PM
    assembly, channels, clear, deg, dish, feeds, galaxy, helps, his, hope, let, like, looks, many, motor, move, need, nimiq, over, signal, some, started, usals, using, west
    • Replies: 2
    • Views: 951
    Last Post: 09-18-2008 07:38 PM
    by cnagorka@gmail.com  Go to last post

    Forum:
    Sadoun PowerTech

  7. DG-280B Motor Back-Lash Adjustments ?

    Started by TexRedNK, 07-13-2008 08:14 PM
    advice, aka, assembly, back, can, etc, file, following, hey, making, might, motor, move, one, other, pdf, right, screws, should, showing, tips, ver, vertical, very, won
    • Replies: 0
    • Views: 985
    Last Post: 07-13-2008 08:14 PM
    by TexRedNK  Go to last post

    Forum:
    Sadoun PowerTech

  8. MKit1B help -- wrong mast bracket?

    Started by kenny0, 03-17-2008 08:22 PM
    all, assembly, different, dish, european, fine, hey, isn, mast, model, motor, moun, mounting, notice, one, other, pic, picture, pole, received, right, some, stuff, why, work, wrong
    • Replies: 4
    • Views: 344
    Last Post: 03-17-2008 09:49 PM
    by kenny0  Go to last post

    Forum:
    Installation Help Requests

  9. dish setup

    Started by gremlin411, 02-03-2008 02:58 PM
    actuator, adjusting, angles, antenna, assembly, azimuth, band, best, declination, dish, distance, elevation, feedhorn, focus, footprints, know, lnb, moun, mount, org, page, polar, polar mount, prime, satellite, systems, ten
    • Replies: 1
    • Views: 626
    Last Post: 02-03-2008 03:19 PM
    by rainman  Go to last post

    Forum:
    Installation Help Requests

  10. Just bought and installed M-3 Motorized Mercury II Blind Search Choice Set

    Started by aeroman, 11-10-2007 10:21 AM
    assembly, calculate, configure, correct, dish, each, east, far, figure, figured, his, lat, location, log, move, point, rotation, satellite, sky, sys, system, usals, watch, west, wish
    • Replies: 7
    • Views: 630
    Last Post: 11-10-2007 02:21 PM
    by teched  Go to last post

    Forum:
    Free To Air Satellite

  11. Install on Rohn 20G Tower

    Started by gregaj, 06-21-2007 12:11 PM
    aiming, align, assembly, better, com, dbs, else, kind, like, make, might, moun, mount, need, obviously, plumb, pole, right, should, some, south, support, sure, ten, turn, variety, ver, vertical
    • Replies: 9
    • Views: 1,514
    Last Post: 06-22-2007 12:03 PM
    by wejones  Go to last post

    Forum:
    Installation Help Requests

  12. Motor Elevation Angles

    Started by Sadoun, 12-05-2006 01:20 PM
    angle, angles, another, anybody, assembly, com, confuse, did, different, elevation, equal, latitude, meter, motor, other, pictures, products, sadoun, sat, set, setting, sg2100, should, some, stab
    • Replies: 1
    • Views: 2,003
    Last Post: 12-05-2006 06:18 PM
    by rainman  Go to last post

    Forum:
    HH Motors

  13. Lost my sence of direction

    Started by pr1947, 08-30-2006 12:08 PM
    aiming, all, amc, arc, assembly, before, can, did, dish, enter, found, install, latitude, lock, make, motor, receiver, same, satellite, signals, south, time, true, usals, way
    • Replies: 2
    • Views: 740
    Last Post: 09-03-2006 09:58 PM
    by Jose47  Go to last post

    Forum:
    FAQ - New users questions

  14. Sathawk and DiSEqC switches

    Started by jmnet, 04-20-2006 07:02 PM
    assembly, built, certain, command, data, diseqc, dishpro, does, feeds, function, hat, like, lnbf, mean, meter, need, order, really, sathawk, software, switch, tha, twin, user, usually, win
    • Replies: 1
    • Views: 529
    Last Post: 04-20-2006 07:39 PM
    by Sadoun  Go to last post

    Forum:
    SatHawk Meters

  15. RA6-074C DirecWay Radio Assembly LNBF?

    Started by Sadoun, 02-24-2006 05:19 PM
    america, anyone, assembly, built, direcway, does, hat, into, ion, khz, lnbf, need, north, off, radio, range, satellites, tha, tone, transponders, used
    • Replies: 0
    • Views: 1,276
    Last Post: 02-24-2006 05:19 PM
    by Sadoun  Go to last post

    Forum:
    DirecWAY

  16. Superdish

    Started by kpeters59, 02-20-2006 10:29 AM
    air, assembly, attached, buy, com, could, directv, fortec, free, fta, keep, lnbf, lnbfs, might, multiswitch, need, new, off, order, receivers, rooms, sadou, sadoun, sat, superdish, try, using
    • Replies: 8
    • Views: 1,214
    Last Post: 03-06-2006 08:57 AM
    by kpeters59  Go to last post

    Forum:
    Installation Help Requests

  17. SuperDISH 105 Conversion To SuperDISH 121

    Started by NightOwl, 11-26-2005 01:47 PM
    assembly, can, channels, com, dish, getting, going, installation, lnbf, need, one, only, point, possible, receiver, replace, sadou, same, see, setup, signal, some, system, try, verify, way
    • Replies: 5
    • Views: 2,078
    Last Post: 08-18-2006 12:15 AM
    by Darkman  Go to last post

    Forum:
    Dish Network

  18. Space Shuttle

    Started by kevision, 07-12-2005 10:26 PM
    119, abc, assembly, building, excellent, fox, foxnews, live, nasa, news, pad, sho, shot, shut, shuttle, space, space shuttle, static
    • Replies: 2
    • Views: 197
    Last Post: 07-13-2005 12:52 AM
    by kevision  Go to last post

    Forum:
    News and Weather

  19. Missing Parts

    Started by zaxxon2000, 07-11-2005 09:23 PM
    assembly, canada, com, contact, digi, digital, dish, email, fortec, hardware, hat, holder, included, lnbf, missing, order, panel, part, parts, pic, pictures, sadou, sadoun, support, take, tha
    • Replies: 1
    • Views: 491
    Last Post: 07-12-2005 11:47 AM
    by Admin  Go to last post

    Forum:
    Installation Help Requests

Results 1 to 19 of 19