Reseting Stab Motor

[riquelme]

Hello,

how can i reset the memory of a stab HH 120 motor for restoring satellite table? The stab has not a reset hole like other diseqc 1.2 motors. I have a Dreambox 600 and a hold humax receiver. Is it possible or do i have to use stab mp02 interface.

thanks and greets

[William Eng]

I may be wrong, but as far as I know, the motor does NOT contain any memory. It is your receiver that has all the satellite locations in its memory.

[riquelme]

hi,

i dont know but the motor stores the positions. I mean i want to restore the satellites table of the motor. If i reset my receiver ( dreambox 600) all positions in the receiver are deleted. Then if i just put the number in the motor menu the receiver drives to the old position, so i know that a reset of the motor didnt work.

Maybe anyone a solution or is a reset of stab motors just impossible?

greets

[Sadoun]

Hi,

Here is the user's manual for the HH120 motor:
http://www.sadoun.com/Sat/Products/S...120-manual.zip

Check instructions in the manual for reseting your motor.

[riquelme]

thank you but i tried this several times. I go to motor menu and i make go to reference but then the satellites are not deleted. Maybe receiver has no reset command?

[rainman]

are you using usals or disqec 1.2?

[riquelme]

hi,

i am using diseqc 1.2 .

[rainman]

if you are using 1.2 when you recalibrate the location of the sat do you store the new position?

[riquelme]

i just drive to zero position. I didnt recalibrate.

[rainman]

once you drive to zero try recalibrating then once you track in your sat be sure to store it's position.