Hh120 Stab Motor

palhome1 · #1 (**permalink**) 10-05-2008, 05:22 PM

Hi
I have a problem with my HH 120 Stab Motor
When I try to change satellite my motor just keep moving from east to west and i have to turn my receiver off to stop it.
so my question is...can this motor be save or i need a new one?????

Vitruvius · #2 (**permalink**) 10-06-2008, 02:02 PM

Try this: Move your motor to 0 manually with the buttons on it. Then do a reset of the motor as described in its manual.

rainman · #3 (**permalink**) 10-10-2008, 08:46 PM

Quote:

Originally Posted by Vitruvius

Try this: Move your motor to 0 manually with the buttons on it. Then do a reset of the motor as described in its manual.

The stab 120 don't have east west buttons you have to use the receiver to set it to 0.

palhome1 · #4 (**permalink**) 10-19-2008, 12:41 PM

I did that and still doing the same moving from east to west

Sadoun · #5 (**permalink**) 10-20-2008, 10:33 AM

What brand / model receiver do you have?
Are you using DiSEqC 1.2 or USALS?

louis5 · #6 (**permalink**) 10-22-2008, 05:08 PM

Palmhome1:
I had the same problem. I changed the RG-6 to a solid copper center conductor. The problem was caused by the steel copper clad center conductor of the cheapo RG-6.
Louis5