I have installed my 36"
satellite dish w/motor
HH90 up on the roof of my house and there are no obstructions whatsoever, when I change satellites on the receiver, the dish turns from east to west and vice-versa with no problems at all, all cables and connections are new and correct (checked and rechecked many times), all angles for my area (Montreal-dish elevation: 38.2°, Latitude: 45.5 N, Longitude: 73.6 W, aimed at true south 194° with compass, are all set right, (also checked and rechecked many times), the post is also perfectly plumb on both sides. I have also inputted the correct latitude and longitude values in the receiver setup and all satellites are set to USALS mode. The cable run is a brand new 100' (30 meter) RG/6
coaxial cable. In my first attempt at
aiming the dish I wasn't able to get the quality bar on the receiver to move at all, but the signal level bar was at 72% to 84% depending on the satellite. So, I bought a
signal finder, the ones with the needle and the buzzer. By the way, what's the buzzer for? I used it according to instructions connecting it between the receiver and LNB and moving the knob to move the needle to level 5. I then moved the dish to the nearest satellite to my south, which is 72.0W AMC 6, by using the receiver in USALS mode. I then proceeded to slowly adjust the dish from side to side and also adjusted the dish elevation one degree at a time up and down. The needle moved up a little but wasn't able to get it to go much higher than a mark on the scale, from 5 to 6 only. I then checked the reading on the receiver again but there is no change. I have tried scanning satellites anyway but of course since there is no signal quality, no channels show up. Can anyone tell me what I may be doing wrong? I am getting quite frustrated with this and I simply don't know what to do next. Could the LNB be damaged? If so, how can I test it? The LNB is a FSKU-V Universal Single LNBF. Or could the motor be malfunctioning? And how can that be tested? All components are brand new. Can I rule out a problem with the receiver? Can anyone help? Any helpful information will be very much appreciated and I thank you in advance : )
Linear Mode
