I need Expert LNB advise

[fogoflyer]

I just converted from a generic cir polar LNB to a new Invarcom QPH-031 and my signal quality has dropped somewhat. Also not picking up the Anik sats like I intended. Getting SBS 6 at 74W at quality 90%

I have a 80cm Fortec dish with a Stab HH90 motor and a Pansat 3500sd FTA rx. My location is central Florida (29N 81W).

Prior to the new QPH my quality on Echo7 was 85% now at 40%, Echo 8 was at 85% still at 85%, Nimiw 1.3 was 95% now at 70%. The signal levels have not changed.

I installed the QPH with leads to the DiSEqC, to the motor, to the FTA.

In my opinion the QPH works ok but for some reason I am not getting Echo 7 like I was previously. Did the extra weight to the dish arm make any difference? If so, how do I compensate.

Opinion requested.

[elgemcdlf]

What are you getting from the Echo sats? What receiver? What are your settings for the lnbf in the receiver? Which port are you working with on the lnbf?

[fogoflyer]

What are you getting from the Echo sats? What receiver? What are your settings for the lnbf in the receiver? Which port are you working with on the lnbf?

Using a Pansat 3500SD receiver

E7 is Level 68% Quality 40% (before Quad quality was 90%)
E8 is Level 70% Quality 56% (before Quad quality was 90%)
E9 is Level 65% Quality 40%
Nim 1.3 is Level 77% Quality 89% (no complaints here)

Lnbf settings
Lnb = Standard
Lnb Freq = 11250
22hz=off
DiSEqC=#4
Legacy=none
skew= -45
TP=122239H20.000 (the Level & quality at this TP is as above)
Pos setting = USALS
Sat scan = all

Not sre what you mean when requesting which port I am working with on the lnb