Can someone give me advice on a digipower sg2100 motor

[vicod]

I bought a pkg deal over 6 years ago with the Invacom bigger dish and motor, everything worksgreat to this day however the connectors that go into the main board the one that makes it move, i must of over tightend it and on a cold day tried to take off cable with wrench well the connector snapped, and all i got was i had to buy a new board, well heres what i did i took it apart took the out connector off and put that one on the input to drive motor again, but its a pain cuz i had to put the motor on disq 3 and i already had 4 spots taken up so split 2 with a 22khz switch and ran the wire thats suppose to go on the out right to the invacom but now i cant use my linear not enough ports andwhen i want to move the dish i got to switch in menu to disq 3 use USALS and have to set disq to 4 and 22khz on thats the wire running to the invacom. my question is does anyone know where to get the connectors that screw into the mainboard and the coax they said it couldnt be done then why did i unscrew the out and screw it into the in to move the motor. all i get is u need a new board there is nothing wrong with my board i just broke in half the one connector. i just need to find out where i can get them from cuz i know they unscrew and screw back in cuz like i said i did it with the in to the out.i tried radioshack and a few other electronic places and could not match them up they r thinner where they screw into the mainboard and im sick of eveytime asking where i got this them telling me i need a new board NO I dont i just need the connectors to screw in to the mainboard, maybe they made the connectors that way in case one snapped in half they tell u to spend 44.95 for a board when all u need is 1.00 connector.I am very disgusted with the run around i am gettin from Sadoun i purchased many items over the years thru them and recommended them to friends, they make these motors so im sure they should have some connectors layin around i would think. but i am not going to waste 44.95 for a board thats not broke all i ask is where can i get the connectors that screw into the board. if anybody out there knows where to get them i would greatly appreciate it cuz im not spend 45 bucks for something not broke, for that matter might as well buy a new one on fleabay for 60 bucks. im sure they can sell them but want u to buy the whole board. i always had great support with sadoun til this. so please if anyone knows where i can find them connectors that screw on the board i wii be for ever at your mercy lol. thanks in advance and i hope some one knows where to get them, thanks......

[Frisky]

gee was that hard to read. Try Jameco, Mouser.com, Digikey.com since you are looking for a part. does that part look like this? HH Motors STAB, Digipower, Moteck, SatControl, Sadoun DisEqC

[Frisky]

What about this one from digikey CONN F FEMALE PCB MOUNT - 6803

[Frisky]

if that's not it take a picture and post it I did a goggle search for "f connector female pcb mount" lots of results for you, did you try that?

[vicod]

thanks for the reply there are 2 thst seem to match cuz the one end gets thinner on the end they r cheap enough i will grab the 2 i think will work and let u know how i make out thanks again for your replys