Anybody--How do I tape a program using the VCR attached

abimimi1 · #1 (**permalink**) 06-23-2003, 07:04 PM

I want to tape a program. Is there anybody who knows how to do that?

bobkat · #2 (**permalink**) 06-24-2003, 12:06 AM

EZ...

Simply connect the TV OUT on your satellite receiver to the ANTENNA IN on your VCR, then the TV OUT on your VCR to ANTENNA IN on your television set. Set the VCR on channel 3 or 4 (to match the RF output of your satellite receiver) and start recording.

:wink:

kat

abimimi1 · #3 (**permalink**) 06-30-2003, 04:57 PM

Simply connect the TV OUT on your satellite receiver to the ANTENNA IN on your VCR, then the TV OUT on your VCR to ANTENNA IN on your television set. Set the VCR on channel 3 or 4 (to match the RF output of your satellite receiver) and start recording.

But the Satcruiser config shows VCR--->Receiver---->TV, that's what I did.(VCR TV-Out to SAT ANT-IN, SAT TV-out to TV). I will try and see.

bobkat · #4 (**permalink**) 06-30-2003, 07:25 PM

Hmmmm.... I just noticed that - the manual is screwed (page 7); ignore it.

Connect a cable from the SatCruiser TV OUTPUT to the ANTENNA IN on your VCR; then connect a cable from the TV OUTPUT on your VCR to the ANTENNA IN on your TV set. Then set your VCR to channel 3 to record programs from the satellite receiver.

kat

:roll: