Diseqc 1.2 function on DSR101 ??

[hangxanhan]

Anyone is familiar w/ the Diseqc 1.2 positioner for the HH sg2100 motor on the satcruiser standard DSR -101. Below is the feature in the Diseqc positioner:

1) select satellite
2) select TP
3) adjust East/West
4) move East/West
5) Set limits (Move E/W, East limit, West limit, Clear limit, Reference)
6) Store
7) Auto-calculation

I was able to get T5 in true south, and G3, G4, AMC6 channels. I stored all of them once I got good signal in DIseqc positioners. But, every time I want to watch a channel, I have to go back into Diseqc positioner in the menu and manually move the dish (via the remote) to the correct dir, and exit out to watch the channel.

Is there a way to tell the receiver to move the dish automatically to the sat that I previously stored? Where can I get the "go to 0 position? I tried the "auto-calculatio" function but it just asked for the confirmation and that's it.

Thanks

[bobkat]

I have had problems with the DSR-101 and HH motors too. Some models work fine - others do not. I believe its a software problem with certain DSR-101s.

kat