LNBF settings in SETUP4PC

[jperquin]

Hi,

I have a Fortec FSKU-v LNBF and I am using a PC card with a program called SET4PC. It is asking me for the following parameters: LOF1, switch and LOF2.

I am trying to setup the software to get BVN on AMC-4, TP21, 12120V.

Any help is much appreciated.
Rgds, JP

[wejones]

Originally Posted by jperquin

Hi,

I have a Fortec FSKU-v LNBF and I am using a PC card with a program called SET4PC. It is asking me for the following parameters: LOF1, switch and LOF2.

I am trying to setup the software to get BVN on AMC-4, TP21, 12120V.

Any help is much appreciated.
Rgds, JP

Not familiar with the program, but that LNBF is a universal, so LOF1=9750 and LOF2=10600. You can put the switch somewhere in between the high and low bands, not sure what is best, perhaps 11700.
However it is possible that your program takes input in GHz instead of MHz that I used above, in which case the 3 numbers would be 9.75, 10.6, and 11.7 respectively.

EDIT: actually, I just realized that I do have that SETUP4PC program (I thought it sounded familiar). However my version came with an Air2PC ATSC card, and the satellite functions are disabled, so I can't use it with my satellite cards, and don't know if it uses MHz or GHz numbers. I assume that your card is a Technisat card??

[Muad'Dib]

That tool normally comes with a Skystar2 card.

I wont use it, use DVBDream, ProgDVB or AltDVB instead.