Fortec 90cm and SG-2100 Motor

[misterdk2]

OK, basic question that I should know the answer to. I know that the motor turns the dish from east to west but does it also adjust for elevation of the dish (up and down)? I figure that it must because of the different elevation calculations for different satellites. I'm just a little cloudy on this. Just got my new Fortec 90cm and will do the setup tomorrow. I'm in Philadelphia and does anyone know of an experienced FTA installer in my area? I've used some of the online installer locaters but without much luck. Thanks guys.

[DruzeTito]

read my sticky here: it has the answer to your question.. http://sadoun.net/viewtopic.php?t=5028

[misterdk2]

Thanks Druze, very informative post. So if I manually, up on the roof, adjust my signal strength to the max on my due south satellite and my farthest east and west sats, does that mean that I will definitely pick up the other sats along the arc of the Clarke Belt? In other words, if I've got the east, west and south all maxed out I will get everything in between? Thanks again.