moteck sg2100 reproghaming

[gerald557]

can anyone tell me how to reprograhm sg 2100 mine moves west when I push east and west when I push east !!! and I want to change all the sat settings and sats in the unit need to know how??? I am using a I Link 9000 plus I have had the sg 2100 about a year or two and this is the first time I have hooked it up.I have reset it several times and run though east and west with the button on the unit and it works fine and the light is orange???? any suggestions All the help is needed and thank all of you that helps in advance I am on the west coast

[Frisky]

Move the dish to 0 degrees. then disconnect the rg6 Coaxial Cable from the receiver. Then press and hold both east and west for 5 secs. There is a way to reset from the receiver. Did you set the receiver to ULAS and set the the long and lat in it?
Don

[gerald557]

Move the dish to 0 degrees. then disconnect the rg6 Coaxial Cable from the receiver. Then press and hold both east and west for 5 secs. There is a way to reset from the receiver. Did you set the receiver to ULAS and set the the long and lat in it?

Don

I tried it and it is the same,

[Frisky]

I'll have to dig out my spare motor I don't remember a orange light. Green light. So your motor is setup for southern hemisphere if the switches are backwards? Do you have your long lat correct in the receiver?