SG2100 where is angle adjustment index?

[billphx]

I am setting up an older SG2100 with a fortec 90cm dish.

The little washers with the index are missing. Where do I set my latitude/elevation with regards to the motor bolt itself?

Is the scale index on the center of the bolt, or on one of the ends, or ?

Also-- where on the motor/shaft can I take an angle measurement (I have an electronic angle meter), with or without having to calculate an offset?

thanks
bill

[yvesj]

Originally Posted by billphx

I am setting up an older SG2100 with a fortec 90cm dish.

The little washers with the index are missing. Where do I set my latitude/elevation with regards to the motor bolt itself?

Is the scale index on the center of the bolt, or on one of the ends, or ?

Also-- where on the motor/shaft can I take an angle measurement (I have an electronic angle meter), with or without having to calculate an offset?

thanks
bill

if you look on the motor bracket you will on one side [lontidute] on the other side you see [elevation] there one arow for the pointer.
now in the dish angle setting there no arows it ion the edge right close the bolt .here is the picture
now on the di