Reference/Reset problem.

[boz]

I connected an old BEC receiver to my motor, and somehow it reset my reference from 0 to 10, so now USALS will not work. I've lost my original manual, and I've tried a half-dozen reset procedures I've found on the internet to get my motor to reset 0 to true south.

I thought my motor was a Digipower/Moteck 2100, but it may be something else as it has separate East and West buttons. You push both at the same time to move to 0 (now 10), and there is a small reset hole next to the East button.

[glen4cindy]

If you manually move the motor to ZERO and press the reset button, it will reset your motor.

You should then be able to use USALS again to move the motor to the proper position. This assumes that everything was working before.

[SatLuv]

BEC is terrible to use with a HH Motor. The menu sucks on that receiver. Don't waste your time with it. Just get yourself a Fortec Dynamic.

Fortec receivers are very stable with DiSEqC 1.2 and USALS. The menu is user friendly.