H180

[Jagee]

Wi have a HH90 and i know were the coax goes to. But this one i don't understand the drawing that you show on your site.ere does the coiax connect to on this motor.Or do i need something else?

[rainman]

you will need something else this is a 36v motor so you will need a box like the v box to move the motor with acuator cable such as 4 wires 2 larger ones for the motor and 2 smaller ones for the sensor.

[Jagee]

I understabd now thank you

[wejones]

Originally Posted by Jagee

so my pansat recever which move my h90 right bnow is no good your saying and were do i get thye cable i need.It ddoesn't say that were i bought the motor,Oh well were do i get what i need my pansat 3500SD is a posioner i thought.

The Pansat and other FTA receivers (except for a couple old ones that I don't think are sold anymore) only control DiseqC1.2 capable motors, ie motors that have some computerization inside to receive commands from the receiver.

That H180 motor is similar in function to an actuator type motor, ie it is just a motor, no smarts, and you need a receiver that controls that kind of motor (most analog receivers), or you can get the VBOX type box, that interprets the DiseqC1.2 commands, and then controls the motor. You might complain where you bought the motor, as they should have been more clear. THe description here at Saduon clearly says "Works with VBOX-11 positioner or receiver with 36V built-in positioner", which rules out the Pansat you have.