SG2100 Upside Down?

[SteveMyers]

I read the other posts here about using some "Off-Brand" dish with this motor, but I purchased both the SG2100 and the 36" Fortec Star FC90P pole-mount dish from Sadoun in the same order.
(The dish was an "upgrade" from the kit's FS80P pole-mount)

1st off, the box with the dish contained the instructions for an 80cm dish, not the 90cm. Completely differnent brackets.
Looking at the pictures on a few websites solved that problem but...

I can see no way that this dish is going to work with an upside-down motor.

The only way I can get the pole mount to fit is to mount it to the dish upside-down. (The sleeve, not the whole dish)
When I do this, it will only swing to about 5 degrees elevation, no where near far enough to see anything.

Whats the deal here???

[SteveMyers]

OK, I'm trying it a different way now.

I flipped the sleeve back so it's up-right and put the long bolt through the sleeve and the top hole on the motor-pole and now I can adjust the dish elevation as normal.

I'm not sure if this would have been explained in the directions, since the correct ones were not in the box.

I hope this doesn't throw off the centerline of the point of rotation.

Steve

[Sadoun]

Here is a picture that might help: http://sadoun.com/Sat/Products/Motech/MOTECH-SG2100.jpg