Hi everobody,
I have installed my satellite reception system with a 80cm dish + rotor
Sadoun SM3D12 + Zehnder D4000DCI receiver and the rotor is operated with Diseqc 1.2
I programmed all channels and satellited with my system and everything worked fine 1 month ago till yesterday.
The rotor doesn't move anymore.
Here is what was happened:
I was watching on a one channel on Hotbird 13°E then I changed to another channel on Astra 19,2°, it was OK. Sometime after I changed to another channel on Telesater 15°W and from there the problem happened.
The dish was first moving some degrees to the west and then stopped and no more movement even I set manual rotation from receiver.
I switched OFF then ON my receiver, the the dish was moving suddenly to the most east position and then no more possible to make it move again from the receiver.
With my laptop I reset and reprogram my receiver, unplug everything then reconnect everything the it works again.
I retried the same operation with channels changing and I got the same behaviour means no more movement from the rotor and is it blocked at the most east position. And I saw on the rotor there is a flashing green Led while the receiver is sending rotation command.
I redo all reset and repgrogramming on my receiver and NOTHING anymore is working with the rotor.
I'm really out of idea how to find back solution, please help.
What is the meaning of flashing green Led?
What will happend if I will try to make move on the rotor itself with the small switches?
Regards,
Linear Mode
