10 Hours and still nothing

[jorge]

CAN SOMEBODY PEASE HELP I JUST GOT THE NEW LIFETIME ULTRA AND I CAN"T GET IT TO WORK I WAS NEVER ABLE TO PASS THE FIRST STEP
I DO EVERITHING IN THE BOOK TO IAM AT ANY SAT BUT I CAN"T GET A SIGNAL IS MY UNIVERSAL LNB FROM SADOUN BROKEN?????????????????
MY SYSTEM = FORTEC STAR LIFETIME ULTRA
ONE 31 INCH DISH
ONE FORTEC STAR UNIVERSAL LNB
ONE HH90 MOTOR
----------------------------------------
I LIVE IN FORT LAUDERDALE FL
SADOUN TOLD ME TO DO THESE SETTINGS
MOTOR AT 26
DISH AT 41
AZIUM AT 186
I DONT KNOW WHAT I "M DOING WRONG
PLEASE HELP

[pictureon]

You have the correct information.
Try this.
On your receiver go to Antena setup, select T5 (97) and make sure the lnb is set to universal. Look at the 2 pars on the top of the screen. If your connections are OK you should see some signal strength there. If you do not see any signal strength check your connections. The second par is your signal quality. Go to the dish and move (Dish and motor as one unit) to the left or right (go very slow) until you see some signal quality. If you do not see that try to adjust the dish elevation (not the motor) up or down untill you get some signal quality.

MAKE SURE MAST IS 100% VERTICAL

[jorge]

i have it finally i lock into nimiq2 wich is my closest sat at 82 because i live in fort lauderdale now this is the part that nobody tells you what do you do next
i scan tha sat and i see like 16 channels thats ok but how do i tell the motor to go to the next sat the one i want is nahuel1 wich on fta will give me some channels from south america but when i tell it to go to that sat it losses the signal this is very hard to do.it isn"t by any mean easy like some people say..please help on what to do next once you find the signal on a satellite
where it said positioner setting i have it at ( usual ) i press ok
and it takes me too
satellite position 82.0 w
my longitude 0.0
my latitude 0.0
reference position ok
move
store

the problem is that if i enter my longitude and my latitude and tell the sat to move it losses the signal i my doing this write....that you

[xwolfs7]

Hi! for you to track your sat you must put in your lat and long then your motor will go to the sat you want...after you enter your lat and long to use remote and press ok on where it says move then it will blink and begin to track if you have it set right it should move to sat of your choice.

[sealizard182]

can i use the same settings as jorge i live in west palm beach fl wich is 45 minutes from him.

my lat is 26.86 n & long is 80.12 w i am not sure wich is my true south or true sat to lock on


i have a fortec 30" dish with a fortec universal single LNBF

thanx in advance