How to remotely reset SG2100?

vitez_koja · #1 (**permalink**) 08-03-2004, 12:02 AM

Hi All,
How do I remotely reset Motor SG2100, by using the BEC 6600 receiver?
Basically what happened is, after I hit "Factory Default", the motor doesn't move.

Here is the info I have in setup menu:
- Disecq 1.2,
- Universal,
- 9750 - 10600,
- 0V.

Am I missing something?
Are these wrong (0V in particular)?
Is it possible that motor is stuck (it doesn't look like it when seen from the ground)?
How to reset the motor remotely without going on the roof, and potentially risking my life... :-)?

Please help....

vitez_koja

vitez_koja · #2 (**permalink**) 08-05-2004, 08:18 PM

Anyone ???

bobkat · #3 (**permalink**) 08-05-2004, 10:26 PM

Check out pages 18 and 19 of the manual under LNB SETUP and TRANSPONDER SETUP. When on the MOTOR screen try using the arrow left and arrow right keys to move the motor. Also see page 21 under RE-SYNC and GO TO 0 POSITION.

kat

vitez_koja · #4 (**permalink**) 09-02-2004, 07:41 PM

I know it is possible to reset the motor by pressing the "Reset" button, BUT is it possible to remotely reset the motor from inside the house?

Thanks

dtsexpert · #5 (**permalink**) 09-02-2004, 10:07 PM

When you hit the reset botton, the receiver will erase all the sat positions which you previously saved. You will need to repgram them.
Michael

Quote:

Originally Posted by vitez_koja

I know it is possible to reset the motor by pressing the "Reset" button, BUT is it possible to remotely reset the motor from inside the house?

Thanks