Need Help With Motor Movment (hh90)

[cyberdemon]

I Finnaly got my motor yesterday and installed it lastnight.

I have made shure the pole is plumb,

setup the p value, (51.6)

calculated my lat and longitude, (32.993019 N, 80.125701 W)

connected the lnb to the motor, ran cable to reciever (fortec lifetime ultra), pluged it in and went to antenna setup and seen that I by chance was allready pointed to 110 sat. so I went ahead and scaned for channels (chose all just cause I wanted to see) I got all of the channels from the 110 sat (only able to view one tv and one radio but it was there)

so after this I went to settings for echo 6,8 and chose these settings

type- standard
freq- 11250
22kh- off
diseqc- off
power- on
tp- 12224 v 20.000
positioner setting- usals
sattlite scan- All

I then went into the uslas settings and imputed my lat and long (32.993019 N, 80.125701 W)
stored it and set as a reference point.

I think I did all of this correctly.

well here is the problem. when I chose a diffrent sattlite and go into the uslas settings the lat and long is there but the motor does not move to it. Is there something wrong with my settings?

I shure hope that my motor is not bad :cry:

Please help me guys I am very excited about this new system I just got (m-1 system from sadoun) and am quite anquious to start playing with it.

[cyberdemon]

Please delete this post.

I did not have it pluged into the correct dish last night.

[bobkat]

Originally Posted by cyberdemon

Please delete this post.

I did not have it pluged into the correct dish last night.

LOL !!!! Not only are we not going delete the thread, we are going to create a "Classic Posts" forum and put it there. :lol: :lol:

kat

[j/k] If you really want it deleted it shall be done... :wink:

[cyberdemon]

ok keep it up if you like

Thats the problem with having several dishes and several wires running in the attic. :lol: