Diseqc 1.2 positioner on satcruiser rcvr

[hangxanhan]

Is anyone familiar w/ the Diseqc 1.2 positioner function for the HH sg2100 motor on the satcruiser standard DSR -101 ? Below is the feature in the Diseqc positioner menu:

1) select satellite
2) select TP
3) adjust East/West
4) move East/West
5) Set limits (Move E/W, East limit, West limit, Clear limit, Reference)
6) Store
7) Auto-calculation

I was able to get T5 in true south, and G3, G4, AMC6 channels. I stored all of them once I got good signal in DIseqc positioners menu. But, every time I want to watch a channel, I have to go back into Diseqc positioner in the menu and manually move and adjust the dish (via the remote) to the correct dir, and exit out to watch the channel.

Is there a way to tell the receiver to move the dish automatically to the sat that I previously stored? Where can I get the "go to 0 position" command? I tried the "auto-calculatio" function but it just asked for the confirmation and that's it.

Thanks