1. Galaxy13/Horizontal1 has no 24/24 active transponder on Ku. Feeds have been pop up on this sat occasionally. You will need to wait for an active feed presents on this sat in order to verify if your dish actually hits this sat.
2. Check T7 transponder list against lyngsat to ensure they are up to date. Some data transponders are 24/24 active so you can verify if the dish gets lock. For data feeds, you will not any any channels when scaning.
3. You can not change USALS. The diseqc h-h mount uses a formular to calculate the sat position base on long/lat. What is your truesouth sat?
Michael
Quote:
|
Originally Posted by ZeroBeat
I can't get G13 at 127W or T7 at 129W. When I move my dish with USALS and scroll through the TP values none result in a quality reading. I did a power scan anyway. When I got quite a few of those little bars/blocks above th "V" and "H" lines, I thought I was good. My dreams were dashed when "0 programs found" appeard :cry: Does this mean I am not tracking the Clarke belt exactly? Should I adjust any USALS parameters? If so, What? (After making sure mast is plumb)
latitude and longitude in receiver?
true south?
motor mount?
dish elevation?
I am getting all channels on other sats I have scanned. (T5, AMC3, AMC4, SatMex5, G10R). I'm not having problems pulling in these channels or transponderswith USALS.
|
ops: 
Linear Mode
