I need help!

[cdssh]

I plan on ordering a fta dish motor and lnb to scan the skies.My question is what type of switch would I need to send signal to 3 different receivers? 2 fta and 1 Dishnetwork.The lnb is the quad invacom qph31 I believe.Would a dish DP 34 work for this setup or would I need something else.And how would I make this work? Sorry for all the questions.But I am new to this.

[elgemcdlf]

Run the coax straight to the DN receiver from a C port of the lnbf. No need to run it through a switch as the receiver (to my knowledge) will not make viewable FTA programming other than their own. Primarily due to the receiver identifying the sat it is on.

As to the other two FTA receivers you have 2 linear ports on that lnbf. Just hook one to each FTA receiver. Again no switch needed. Use one of the FTA receivers to drive the motor.