2x90cm 2xlnb's 0.4 1xmotor what switch ??

Any idea if the 4x2 switch will work for this config ??

1 dish will be stationary the other motorized

1 lnb connector is 18v and the other is 13v surely this is not good ??

Surely both should be 18v and 13v at the same time to have both H and V on both lnb's ??

3 receivers eventually , 2 at first + 2 FT59T cap's.

Okay just read about master and slave powering the motor .

I presume that by only having disecq on in 1 receiver and using this to move the dish is the best config.

Might have a pass power on all spliter arriving soon , will this cause receiver failure even though only 1 receiver is disecq on and moving the motor on 1 dish ??

The pass power on all 3 to 1 switch can then be used to only switch on the receiver of choice to move the dish and not have to rewire. Obviously with moving the dish with 1 receiver and then switching off the disecq on that receiver etc. then moving to another receiver / room and moving the dish again and disecq on again etc.

My orriginal post here refers to 2 lnb on 2 dishes with only 1 motorized and one only lnb getting 13/14v and the other 18/17v ??

I though that 18v is say for horizontal only and 14v is for say vertical , sure this can not be that limited ???

Or will both lnb's have both H and V working irrespective of the voltage and the best is to have the 18v then connected to the motor dish + lnb ??

Sry tryed to search but by the 5th time entering the special code + word I get a bit agro.