Quote:
Originally Posted by sk060
hello:
i have 2 dishes 500 one with the 61.5 and one that has 110&119, i hooked them up to two different disque because i have two recievers, every thing is working fine and beautifull. i tried to hook up the 3rd recievers 3500sd so iread the instructions and i took the connection that says (IF OUT) from the back of one of the recievers and hooked it up to the 3rd one it worked fine but one of these recievers has to be off and if you are watching a Horizontal transponder on one reciever, you have to watch a horizontal transponder on the second and if you are watching 119 you can't watch 110 on the other that is in regards the recievers that i hoked up together the 3rd one is working fine because it is a dfferen switch, is there is any solutions to hook up this miss i have that each reciever would work on it's own because i know i have dual lnb's out put so i have 3 lines going into one switch and 3 other lines into the 2nd switch. by the way the 3 recievers is 3500sd. pls i need help.
|
Not an expert but will try to help:
If I understand correctly you want 2 motorized dishes with ?? 2 lnb's / 2 cables to feed 3 receivers.
If this is correct then like I explained above you will need maybe a
S-DS41C 4-Way
Sadoun DiSEqC Switch
or similar and then use the F59T terminator end cap to block the un-used open connections unless you get a 2 lnb to 1 cable switch ?? .
This should get all the lnb signals into 1 cable.
Next to split to receivers:
Then get maybe a 4 way splitter as this will take the feeds from all the lnb's and pass it onto all the receivers you have , all the satellite you are locked onto will show up on all you receivers.
Again close of the open connection you are not using with a F59T.
This should reduce your amount of cables and have all the recievers working without problems.
Also might want to get the best quality cable ?? RG11 ? to carry the signal in between the switch and splitter.
Might just have to set 1 receiver to move the dishes and the rest to only watch the channels and NOT move the dishes.
Make sure the switch can pass the disecq signal from any receiver to the dishes.
You get 2 versions 1 that will only pass a signal from 1 receiver to the dish but still combine and split or 1 that will have all ports pass the disecq signal to all dishes.
You likely want the 2nd one as it is about the same price but does not limit you to moving cables / changing connections later on only change settings in receivers menu.
You might want to run this by one of the more experienced persons on the forums here as this is my understanding and how I would do it.
.jpg){kind=avatar}
Linear Mode
