how to install HH90motor with invacom qph-031

[elvis24]

hi i just bought a Invacom qph-031 LNB (c-band ,Ku-band)
but i don't know how to install it , i have 31"dish with HH90motor i wanna ketch FTA chanells(97.5)and Disch (110) but i dont know how to install it

thanks for help

[rainman]

installation to the dish is the same as other lnbf. now to install it to your receiver you will need a disqec switch run the L port to the number 1 port of the disqec switch run from c port to 2 port of disqec switch run receiver port on disqec switch to motor in port. always put disqec between lnb and motor.make sure to terminate all open connections.

[wejones]

Originally Posted by elvis24

hi i just bought a Invacom qph-031 LNB (c-band ,Ku-band)
but i don't know how to install it , i have 31"dish with HH90motor i wanna ketch FTA chanells(97.5)and Disch (110) but i dont know how to install it

thanks for help

Just so there is no confusion (may have been a typo above), that LNBF is NOT "c-band ,Ku-band" as you say above, it is linear/circular. You can't do C-band with a 31" dish.

[rainman]

good catch Bill I did not see that.as Bill said the qph-031 will not do c band just circular and linear ku.

[elvis24]

but can i still catch Dish (110,119) with circular

[wejones]

Originally Posted by elvis24

but can i still catch Dish (110,119) with circular

There are only a few of the Dishnet channels that are FTA, ie things like NASA, GOL, and some music channels. Nearly everything else is encrypted.

[elvis24]

i tryed but no luck i connected c- to lnb1 on disqec switch and l- to lnb2 on disqec switch and OUt on disqec switch to LNB on motor and REC from motor to my Reciever , i don't know what i did wrong

any help any pictures that shows how to do it

thanks

[rainman]

remember to set your lo freq in your receiver to 11250 for circular and 10250 for linear.