Ok, I'm in New Orleans and have to set my Latitude to 30/Elevation to 60. Now the SG2100 has an elevation washer I had to put in. The washer has two pointy parts under the bolt itself and a flat part with the word "DOWN" on it. Do I set the angle according to the two pointy parts under the bolt or the bottom of the washer marked "DOWN"? Thanks.
Ok, I'm in New Orleans and have to set my Latitude to 30/Elevation to 60. Now the SG2100 has an elevation washer I had to put in. The washer has two pointy parts under the bolt itself and a flat part with the word "DOWN" on it. Do I set the angle according to the two pointy parts under the bolt or the bottom of the washer marked "DOWN"? Thanks.
From a post I made a couple weeks ago,
Ie I found that it was just forward of the little "pointy parts". However I think the way you can confirm this is to verify that what you read on the elevation side is 90 minus what you read on the latitude side.
Linear Mode
