Can't get any luck installing
QPH-031! I use orasat 5, fortec star 95cm dish, no switches, straight cable to receiver, no motor(fixed position).
Here's my story. Using above equipment, I receive 61.5w with original Dish netwwork circular LNB, excellent quality. Switching to QPH-031 brought me "bad/no signal" message. I used "C" port and single cable, no swtiches. Here's receiver setting for LNBF:
LNB type : Standart
High LO :11.250
Low LO : 0
Power : ON
0/22 Khz : 0
DiSeqC : --------(none)
Hooking up back to original Dish netwwork LNB(without changing az/el) brings me the same excellent picture. While using QPH31, I also tried to ajust a little bit az/el(because of QPH weight)and LNBF skew, but still no luck. When I put dishnet LNB back to dish, no problem with signal. I even emailed to
Invacom, they said , all 4 outputs suppose to be in use(DiSeqC). I tried that too, same result. By the way, it was second Invacom I ordered from different company, because I had the same problem with 1st Invacom - I thought it's probably faulty(I have 2 of them now, neither one of them working).
So, what could be my problem? Does anyone using QPH-031 just for one satellite and non-motorized dish? Please, help! :mozilla_frown:
Linear Mode
