help. 90cm dish qph-31 invacom and hh120

[ae50mag]

i need help in south carolina. installers?? 36" fortec dish and pansat 3500s and hh120 motor. what is true south sat for 34.5 n lat and 82.9 w long, the dish is offset with motor bracket elev adjustment and dish elvation adjustment. i am get a constant 69-70 signal and no quality, no matter where it is pointed. what i need is both elevations for this dish for my location. two points of adjustment for this dish and motor.

please help, lost in upstate sc.

[pmb1010]

Put motor at center position.
Mount on a plumb pole, and use a compass and point the centerline of the dish at 187 degrees using a compass (your magnetic adjustment adds 7)

Follow this directions:
http://www.sadoun.com/Sat/Installati...ion-Angles.htm
to calculate the dish elevation. I come up with 24 degrees.

You can use AMC5 as a satellite to line up to.
Pick USALS in the settings, put in your logitue and latidude in the menus for your location. Pick 11742V as the transponder to use. Have the motor drive to AMC5. It will only move a little bit.

Now look for the Utah eduction network screen on that channel. Move the whole motor assmebly side to side, and dish elevation to find the sat.

Leave the motor's bracket to your lat at 34.5 that should not be adjusted.

Good luck