Side support bracket on Fortec 90 CM Dish

blusky · #1 (**permalink**) 10-01-2005, 07:15 PM

I started instalation today on the Fortec 90CM Dish. I am mounting it on a wall and having a tough time with the two support brackets. It seems that when I get the Pipe plum the support brackets are about an inch away from the wall. Can you bend these support brackets to make it work? Any Ideas or suggestions will be greatly appreciated.

bobkat · #2 (**permalink**) 10-01-2005, 07:50 PM

Quote:

Originally Posted by blusky

Can you bend these support brackets to make it work?

Yes, just bend them until they touch the wall. Sometimes its easier to drive the screws on a slight angle. You will find the mast tightens up nicely once the support arms are secure. It is far more important to have the mast plumb than have the support arms a bit crooked.
kat

blusky · #3 (**permalink**) 10-01-2005, 08:20 PM

Thanks Bobcat for your help. I will give it a try again in the morning. So far seems the only thing that has slowed me down a bit. I have the Stab HH100 set up and the dish. Thanks again.