problem with hh100

[Fllinton]

hh100 motor seems to be weak. it gets to the west position and it sits there it won't come back to east unless you help it back any suggestions on what might cause this? i have checked voltage to motor 13.96,
continuity is fine ,also check with another receiver.this is the second hh100 motor they have sent me. it is a 90cm fortec star dish with a invacom quad lnb?this is a brand new setup what eles can i check or do

[Admin]

When you move the dish, try using a Horizontal transponder. The voltage will be higher and the motor will move faster.

Check your cable. It must be RG6.
Connectors must be of high quality.

[Fllinton]

the cable is the monster cable rg6 and the connectors i am not sure of i will order some today and i have tried the horz. movement.
i will report back findings later after changing connectors

[Fllinton]

still no go replaced all connections, tried different cable, different receiver,still can move east to west but if it gets to far east or west you have to help it back
what are the chances of the invacom quad lnb weighing too much

[Admin]

Try taking the LNBF off the dish, then rotate the dish. If the DISH rotates fine, then the weight could be a problem.

[Fllinton]

findings
i tilted dish to lower elevation and moves fine i think this motor is weak
plus it is the second motor they have sent me :mozilla_frown: