GBox V3000 Positioner - Dead?

jmnet · #1 (**permalink**) 05-28-2008, 10:07 PM

I received my GBOX V3000 positioner last week. Took a couple days to program it but finally got it done. It was working as good as expected, except today it seems like it just died. Unplugged the unit to see if something needed to be reset, no luck. Disconnected all cables, no luck.
Any advise, I suspect it needs to be RMA'd.

Thanks.

carl1961 · #2 (**permalink**) 05-28-2008, 11:36 PM

did you unhook the wires off back , I have a V-Box and Mine swiched off because I tryed to use the wires from my motor on two receivers , in other words a short wire from the motor or reed switch will shut it down, unhook all wired and do a reset

jmnet · #3 (**permalink**) 05-29-2008, 08:22 AM

Tried that. Won't power on without any wires.....