LinkBack URL
About LinkBacks
View Profile
View Forum Posts
Reply With Quote
Private Message
Have you checked with Sadoun he may be able to help you.
I am showing a picture of the bracket for the reflector that i have in the first attached picture it is a fc90p. I am looking for the attachment, replacement brackets for a fc90u to hook to a dg380 motor. Can any one help? The 2nd picture is what i am looking for. That is the reflector brackets, the lnb arm, and the u-bolt bracket that goes to the motor.
Please help!
Thanks
Have you checked with Sadoun he may be able to help you.
Rainman's Equipment
Undien 4600,DSR 922 Fortec Ultra, Satworks 3618 Sathawk pvr 800
2 Fortec Mercury II Fortec Classic NA DVB World USB 2104D
8.5' Orbitron polar C Ku dish 8.5' Birdview HH C Ku dish
100cm Fortec dish 90cm Fortec dish
2 DG-240 HH motors Co Rotor II feed horn
Norsat 8515 C band lnb Norsat 4506A Ku lnb
BSC-621-2 Lnbf Invacom QPH-031 Lnbf
Invacom SNH-031 Lnbf Fortec Fsku-v universal Lnbf
V-Box G-box
I Like To Shop at Sadoun Satellite Sales.www.sadoun.com
No luck at sadoun, tried there first. That is unless i am looking in the wrong place. There was no option to buy what i was looking for. The only option was the whole dish. The picture shows way I need the other setup.
Last edited by ASDFLKJ; 10-19-2009 at 01:54 AM.
The easiest thing, and a better install is to just switch out the tube on the motor to a smaller one. Sadoun has it for $13. Check on the HH motor page...
42mm Replacement Tube for PowerTech DG240, DG280, DG280B, DG380 Motors:Use this tube if you are going to use a small dish under 95cm.
Should be an easy fix. It is better, because, you see there is a bolt that runs throught the arm and helps fix the direction on the tube. The other mount is just a friction fit.
VA 39N, 78W, Mercury II, Fortec 31", 36", 72", SG2100, DG-280, H180 (two DSR-922's sitting in a closet and to be the next project) HDTV TV with no pay tv.
Have the dish just want the brackets. Do you know where to get them. Have a 36 inch dish don't want to go smaller. The brackets i need will work just can't find them.
Do you have the pole mount as shown in the photo?
Which one the 1st or 2nd photo. Have the one in the first, need the brackets for the reflector and the u-bolt mount bracket.
Hi,
I think we still have a U-Bolt bracket in stock. It is not listed on the website anymore as we thought we ran out of stock. But we found a few in stock. Call and ask the sales rep to check with warehouse. It is $10 plus s/h
I need the reflector brackets also, so that i can attach the u-bolt bracket to the reflector. I have the one that is in picture 1, need the setup that is in picture 2. Is that possible.
Ok, I just noticed from your picture one that you have the newer Fortec 80cm dish not the older one. On this newer one the U-Bolt bracket will not work because the the LNBF Arm is different.
There are currently 1 users browsing this thread. (0 members and 1 guests)
Posting Permissions 
Visit Homepage
