Install Help

[pmb1010]

If the LNBF is a "Stanard" type linear, then the frequency to set would be 10750.

I did not look up what model you have. I assumed the original poster knew...

[BYX]

For the QPH031 you have to set linear sats on 10750 and circular sats on 11250.

[GROUNDLOOP]

Hi all,
I live on the Island of Freeport In The Bahamas which is about 98 miles southwest of Florida. I have been trying for sometime to receive any fta bird. I have 31" fortec dish, SG2100 motor,Invacom four port lnbf and a viewsat receiver. I can receive signals from sats that we are not allowed to talk about in this forum ( 110 and 119). I am only interested in fta sats any fta sat in my area. There is no zip code in The Bahamas which makes it difficult to get my exact coordinates.
Thanks for your help

Hi, go to NOAA on the top right page on search type CALCULATOR it will take you to the information you need, you will even see the roof top of your house.Check out your noon hour use a plumb bob to find your true south, I hope this helps, good luck.....

[mdm]

I set my QPH031 ( LNB fREQ.) TO 10750 and manually enter TP 11734, no signal yet. But will keep trying.

[BYX]

I set my QPH031 ( LNB fREQ.) TO 10750 and manually enter TP 11734, no signal yet. But will keep trying.

On a motorized setup first make sure to go with straight cable no switches to the lnb, the make sure you have 0° SKEW, then you have to adjust azimuth, ELEVATION and DECLINATION.
Make sure you do very fine adjustments, don't do coarse movements because satellite dishes are about precision.
Patience is imperative.