invacom & cubavision

[mr.invacom]

pas 9 cubavision 11532 H... has anyone received this signal
using a Invacom lnb. Pas 9 is located at 58W
thnks!

[mannydish]

pas 9 cubavision 11532 H... has anyone received this signal
using a Invacom lnb. Pas 9 is located at 58W
thnks!

is the lnb universal, plus u got to put universal setting in box and the elevation is around 40 let me know or i can get u the answer tomorrow

well i used a fortec universal i don't know if make a differents, let me know

[mannydish]

well those lnbs really are expensive but i remenber i triied a fortec universal and really work good for cubavision but if u got too much problem try the hispasat @ 30 will work better.

[mr.invacom]

well those lnbs really are expensive but i remenber i triied a fortec universal and really work good for cubavision but if u got too much problem try the hispasat @ 30 will work better.

thnks for response! I just looked in my shed, found a universal lnb,
cannot try hispasat, as Pas 9, is the lowest Satellite I can see, I live
in Calif.

[RFenergy]

Mr Invacom,

I have seen Cubavision at 30W with an invacom LNB
on a 90CM dish. But with a 300CM dish and a universal
LNB (the 621-2) I don't see it (at either location).

As a sanity check I do see the British Telecom test
card on Ku at 58W on the big dish.

I will keep tweeking because I would like that signal.

This is from Maine where 30W is elev 26 degrees.

RFe

[Jim-S]

If you have the QPH-031 the freq. of the LNB does not go low enough to get Cubavision. The QPH-031 LNB range is 11700 to 12200. You would have to use a universal LNB that will go down there. Also Cubavision shows DVB and not FTA for Intelsat 9 in Lynsat and make sure when you do your scan that your start freq. is set low enought to get 11532 H.
Just food for thought.

[mr.invacom]

If you have the QPH-031 the freq. of the LNB does not go low enough to get Cubavision. The QPH-031 LNB range is 11700 to 12200. You would have to use a universal LNB that will go down there. Also Cubavision shows DVB and not FTA for Intelsat 9 in Lynsat and make sure when you do your scan that your start freq. is set low enought to get 11532 H.
Just food for thought.

so if cubavision was at 11800, then the invacom quad would work correct?

[rainman]

so if cubavision was at 11800, then the invacom quad would work correct?

yeah it would work just fine.

[RFenergy]

I finally got a signal for Cubavision on Ku at 58W.
This is with a NOT optimal setup (focus, azimuth,
skew all need fine tweeks) but, on the merc 2
with a BSC-621-2 it is on the harry edge at a
quality level of 28. This with the 300cm dish.

No such luck with CCTV on C band at 58W....
I don't get any level on that TP. Is anyone
getting that?

RFe