newbie on motor !

[creative-]

intend to purchase hh90motor
my question is if some one wants to run linear on motor and cirular on separate dish with one receiver . is it possible ? if so how . thanks in advance

[boroda1]

Should be easy - just make sure that DISEqC switch is placed in line between motor and linear LNBf, not between receiver and motor. The other dish should have single or dual circular LNBf, no "twins/quads"

[creative-]

thanks for the reply. can you make a small diagram plz. if you don't mind.

[boroda1]

Hope, this picture will help:

[creative-]

Hope, this picture will help:

boroda1.... thankyou so much for prompt help.

[creative-]

Hope, this picture will help:

boroda1... i have a another question for you ( by the way i did according to your diagram and it works perfectly )
tell me on 18" dish if some one has 2 circular LNb. how can you figure out that?

[boroda1]

DISEqC switch with 4 inputs, like

S-DS41C 4-Way Sadoun DiSEqC Switch,

will solve this: you will use one input for linear LNB, and 2 - for 2 circular ones.
I attached circular LNB to the side of linear one, on motorized dish, so I don't need 18" dish for fta.