Results 1 to 2 of 2

Thread: Site location for C-band dish

          
   
  1. #1
    ozifer is offline New Member Newbie
    Join Date
    May 2007
    Posts
    24
    Rep Power
    0

    Site location for C-band dish

    Hi All,

    I think I am going to start looking into settiing up my c-band dish. I have a Ku band dish that hits all the satellites over the us. Should I be ok putting the c-band dish in the same area and still be able to hit the same satellites as the Ku band dish? I want to make sure I am putting it in the right spot as it would be a major project to dig it out and move it :-). I have so far been able to aquire a 8.5' and 10' mesh dish's. My 90c ku dish sits about 1.5 feet off the ground, would I be safe in putting the c-band dish so that it is that close to the ground or should I put it up higher? Any other suggestions please toss out. I am going to go back and read all the threads again I have not read them all since last year when I was wanting to put a c-band dish up.

    Thanks for all the help, everyone here is very helpful.

    Oz.

  2. #2
    rainman's Avatar
    rainman is offline Moon Shiner ModeratorExpert
    Join Date
    Oct 2005
    Location
    Louisa KY
    Posts
    5,579
    Rep Power
    848
    putting it in the same area should work just fine as long as the dish is high enough off the ground so it don't make contact should be fine but would recommend raising it high enough to mow around.
    Rainman's Equipment
    Undien 4600,DSR 922, Fortec Ultra, Satworks 3618, Sathawk pvr 800,Openbox S9
    2 Fortec Mercury II, Fortec Classic NA, DVB World USB 2104D,Pansat 4500PVR
    8.5' Orbitron polar C Ku dish, 8.5' Birdview HH C Ku dish
    100cm Fortec dish, 90cm Fortec dish
    2 DG-240 HH motors, Co Rotor II feed horn
    Norsat 8515 C band lnb, Norsat 4506A Ku lnb
    BSC-621-2 Lnbf, Invacom QPH-031 Lnbf
    Invacom SNH-031 Lnbf, Fortec Fsku-v universal Lnbf
    V-Box, G-box


Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Similar Threads

  1. Ends of the arc/your location?
    By cnagorka@gmail.com in forum Motorized Free To Air
    Replies: 12
    Last Post: 04-28-2009, 06:02 PM
  2. Dish clamp location on rotor shaft
    By Cincy in forum Moteck Digipower
    Replies: 5
    Last Post: 01-03-2007, 08:19 AM
  3. What size dish for this location?
    By furtheraway in forum Dish Network
    Replies: 0
    Last Post: 05-19-2006, 07:03 AM
  4. SG-2100 Location
    By Satellite in forum Moteck Digipower
    Replies: 0
    Last Post: 12-25-2005, 09:20 AM

Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •