No signal what i'm doing wrong??

[patopato1976]

i bought a 90cm fortec star dish with Mercury II Receiver, Digipower SG-2100 Motor, QPH031 Quad LNBF, SM21H 22KHz switch. i installed it in the roof with the motor pipe looking up, wher i put the dish elavation at 24, and the motor at 38 (wich i thinks that this are the ones) i get no signal it all, what i'm doing wrong???

Springfield, VA
Latitude: 38.737°
Longitude: -77.235°

Pls help

thanks

[William Eng]

Originally Posted by patopato1976

i bought a 90cm fortec star dish with Mercury II Receiver, Digipower SG-2100 Motor, QPH031 Quad LNBF, SM21H 22KHz switch. i installed it in the roof with the motor pipe looking up, wher i put the dish elavation at 24, and the motor at 38 (wich i thinks that this are the ones) i get no signal it all, what i'm doing wrong???

Springfield, VA
Latitude: 38.737°
Longitude: -77.235°

Pls help

thanks

Slowly raise your dish to 29, and watch your meter for signal increase.

[BYX]

Make sure to setup the correct frequency on that QPH031.

10750 for lineal.

The closest lineal satellite to your true south is AMC5 located at 79.0°W.

For the motor make sure you have the mast 100% plum, otherwise you will have lots of problems with your arc.

[glen4cindy]

Originally Posted by patopato1976

i bought a 90cm fortec star dish with Mercury II Receiver, cPanel®SG-2100 Motor, QPH031 Quad LNBF, SM21H 22KHz switch. i installed it in the roof with the motor pipe looking up, wher i put the dish elavation at 24, and the motor at 38 (wich i thinks that this are the ones) i get no signal it all, what i'm doing wrong???

Springfield, VA
Latitude: 38.737°
Longitude: -77.235°

Pls help

thanks

Motor pipe looks down on that motor! I think you have it upside down.