H180 motor What cable I need?

alero · #1 (**permalink**) 11-01-2007, 06:27 AM

I bought MKIT5 because I'm interisting to get c & ku band ,BSC621-2 ,180cm dish and H180 motor,now my question is *what kind of cable I need*

to run from motor to receiver.I have a 2500 pansat receiver.I see in the motor guide M1,m2 sensor .I need help thank's.

wejones · #2 (**permalink**) 11-01-2007, 08:16 AM

Quote:

Originally Posted by alero

I bought MKIT5 because I'm interisting to get c & ku band ,BSC621-2 ,180cm dish and H180 motor,now my question is *what kind of cable I need*

to run from motor to receiver.I have a 2500 pansat receiver.I see in the motor guide M1,m2 sensor .I need help thank's.

I don't have any direct knowledge of the Pansat 2500, however most FTA receivers cannot control a big dish actuator or H-H motor like this. You will probably either have to get a VBOX type controller or get an old analog receiver to move the dish.

rainman · #3 (**permalink**) 11-02-2007, 06:58 AM

see if this helps.

alero · #4 (**permalink**) 11-02-2007, 11:16 AM

Rainman the squema help but the wire runing from motor to m1 and 2 is a regular electric wire or if a special one.Thank's.

rainman · #5 (**permalink**) 11-02-2007, 11:56 AM

Quote:

Originally Posted by alero

Rainman the squema help but the wire runing from motor to m1 and 2 is a regular electric wire or if a special one.Thank's.

it's a special wire that has 2 motor wires and 3 sensor wires and a bare drain wire. do a google search for c band and you should find a company that sells it. if not PM me and I will let you know where you can find it.