how do I get circular stations?

Charlie Baker · #1 (**permalink**) 09-30-2007, 08:57 PM

Hello everyone,

I am really relieved, having found a few satellites, and am enjoying seeing whats up there. I see that angel one, on IA5 is circular, and I did a power scan, and it looked like it loaded the transponder that angel one is on, but I do not find it in my channels. Do I have to look someplace else because it is circular, or do I not get it, or what? Thanks for any ideas, charlie.

rainman · #2 (**permalink**) 10-01-2007, 07:58 AM

I don't know what sat you are looking at because IA5(G25) is a linear sat no circular signals.

Charlie Baker · #3 (**permalink**) 10-01-2007, 03:36 PM

Ok, I knew that. I have 2 satellites loaded, ia5 and echostar 7. It is on echostar 7 that I tried to find angel one. As I watched the downloading, I thought I saw the transponder being loaded, but all I got on echostar 7 was a few (4) channels that were basically nothing.
I am also the one who posted about losing the satellite coordinates in usals on my hh100 motor. I did the factory reset of the receiver, and then gave the command to the motor to go to 0, but I still have nothing. It goes all the way west, no matter what satellite I ask it to point to. I have used diseqc to put in what I have, and it works fine, but no usals. Any suggestions?