scanning for signal

[treeman]

Hello, I have a 10' mesh dish with a co-rotor and a dsr 922. Ihave about 10 or 12 sat's found with this system. I subscribe and recieve
several chanels clearly on G4/X4 in ku band.I have a fortec lifetime ultra hooked to the ku feed from the dish than looped through to the 922. The 922 is hooked to the tv with rf cable and the ultra is hooked with rca cables to the tv and switched in with the input on the tv remote.
I parked the dish on X4 and here is where I wanted to go; G16/K19
slot d-9mhz DLfreq 12093.5 H SR6.148936 fec 3/4. So I went to advanced scan on the ultra and entered this antenna info; lnb standard
lnb local 10750 lnb on TP11760 13235 scan all. I than entered the freq
(which was already programmed in) the SR and the fec. It searched and found 0 channels with signal at 55 and quality pegged out at 0. I could switch over to the 4d and had a quality of 60 on several channels. I did a power scan and it found 4 channels (msnbc cnn and 2 others) but could not watch them for some reason. I confirmed on the internet that some people were getting this feed in my area. Does anybody have any suggestions, thank you in advance.
treeman

[teched]

Trying to get the IdeaCast mux?

http://www.lyngsat.com/galaxy16.html

[treeman]

Just trying to get a Uof M football game, as it was beamed around the state.