500plus

steve12 · #1 (**permalink**) 10-11-2006, 06:53 PM

Hello
I am trying to connect a dish network 500 plus dish to a 322 reciever.
Through a dp34 switch. Ican get the signal. But when do a check switch
Iget a reception error. saying this not adish pro lnbf . The label on it says it is. What am idoing wrong?

pictureon · #2 (**permalink**) 10-12-2006, 03:07 AM

Make sure you have 3 lines from the dish going to the switch and 2 lines from switch to receiver. Dish500+ comes with one Dual dp lnb and one fat twin lnb (FS,DS).
On wich port of the switch do you see the error. 1 2 3?

steve12 · #3 (**permalink**) 10-15-2006, 06:40 PM

Hello
I connected two lines to the 322 DISH PRO PLUS reciever, and get a message after checking the switch .
The non Band stacked QUAD on port 1 and 3 is not supported as a diseqc device.
port 1 dp feed 119
port 2 dp single 110
port 3 dp feed 118

Satellite Input 2
lnb status direct connect to a Dp feed
Port 1dp feed 119.

Now What am I doing Wrong?
Thank you!:confused:

pictureon · #4 (**permalink**) 10-16-2006, 03:12 AM

Quote:

Originally Posted by steve12

Hello
I connected two lines to the 322 DISH PRO PLUS reciever, and get a message after checking the switch .
The non Band stacked QUAD on port 1 and 3 is not supported as a diseqc device.
port 1 dp feed 119
port 2 dp single 110
port 3 dp feed 118

Satellite Input 2
lnb status direct connect to a Dp feed
Port 1dp feed 119.

Now What am I doing Wrong?
Thank you!

Looks like you have a problem with input 2. Input one looks good. Trace the line going to input 2 and make sure the connector is secured.Connect the input 2 line to different port of the switch and try again. If you get the same result, then I would say you have a bad twin LNB (118,119)