Yes, it was in the other thread. I goofed up and had wrong voice with the channel, but it was only a preliminary test to confirm the LNB worked so that was OK.
Yesterday, I installed the
120cm dish on my install pole and rotor.
Found the push up pole is a bit weak for the big dish, so I took the time to change that to a long piece of galvanized tubing I was using for ham beam mast a while back. Got the motor installed, but I had the wrong setting for USALS (1 degree off on my longitude, I think I was compensating for the other dish that got moved out of alignment..)
I had to compromise on my highest sat (AMC5) and getting a signal from IA6 (I use the church channel on that one as a line up guide)
So I'm not tracking perfectly. I lost WB because there is a tree.
I'm only getting 1
C band sat at this point (AMC1), because there is a very clear dip in tree level at that location.
I either need to move my dish up on the pole, or move it a bit so it sees over the tree level. I have a nice dip at AMC5 (center of attached pic, that that troublesome tree, then about 95 on is ok till a HUGE tree at neigbors yard that blocks G10R)