Good morning i hope somone has some light into my problem??
My setup: Fortec star 36 inch dish,
sm3d12 motor, Pansat 2500A
receiver, 4 in 1 disec switch,
Invacom Lnb=2 circular 2 Linear outputs.
Here is were i have my problem i star off with a blind scan of 110
with my motor set at around 40 degrees and my dish at 39 degrees
i am at 79.9 degrees west and 43.3 degrees north.
On my screen that shows the signal meter it is at around 70 percent
and after a do a scan and save the quality is around 97-98 percent
but here is were i am not sure what is going on because after the
blind scan is done and it has found x amount of transponders and
goes to the next step and finishes the channels found there are only
a minimal channles that show up for example 8 t0 ten channles on 110
and around 15 on 119, but here is the funny thing on both sats alot of
number of radio channels come in insted can someone ched some light
and help me.
Thank you.
Atec :mozilla_frown: