adding satellite to receiver

lpgao939 · #1 (**permalink**) 10-05-2005, 01:16 AM

I added new satellites to my setup menu. But I can not input degree information (95w for G3C, 97w for IA5), so how can I use HH motor for my dish to find those two? My receiver is Eagle star clone Pantec 2500.

DruzeTito · #2 (**permalink**) 10-05-2005, 02:37 AM

you should be able to set it when you actually go into the USALS setup in the installation. Im not sure about how your receiver is organized but generally look there. Im talking about the section where you input your longitude and latitude.

lpgao939 · #3 (**permalink**) 10-05-2005, 08:54 PM

I dont find this section on my receiver. My receiver is clone of Pansat 2500 and its name is eagle star.

DruzeTito · #4 (**permalink**) 10-05-2005, 09:13 PM

well its the same.. goto antenna setup or installation.. then select the satellite you made... then goto positioner setting and switch it to USALS.. then hit OK on usals.. then you will be in the positioner menu where you can set your latitude and longitude and also set the degree location of the satellite. Look hard.. its there. Experiment with all menu options and youll find it.

lpgao939 · #5 (**permalink**) 10-05-2005, 11:39 PM

Thanks lot. I did what you said. But if you did not tell me I would never know how to do it or there is no information available even receiver manual.

DruzeTito · #6 (**permalink**) 10-06-2005, 01:37 AM

yea i know those manuals are very bad. The grammar and spelling too!