Big Dumb Guy Needs Help (119???)

[BigMorty]

I can't be the only person with this problem, but my searches aren't turning up anything. If this is a dumb question that's been asked a million times, I apologize. Pointing me in the right direction would be much appreciated...

MY PROBLEM:

I'm using a Dish 500 satellite (Dish Network), a Dish Pro 301.013 receiver and a DishPro twin LNB. I'm in southern Georgia, so my key settings are Azimuth 232, Elevation 40, Skew 131.

At these settings, I get nothing. It's only when I knock the elevation to ~60 that I pick up the 110 satellite. But there's no sign of the 119. I've drug my elevation and azimuth all over the place, and still nothing. I can get the 110 strength up to almost the peak (125), but my system always say "Wrong Sat" when I try to get 119. My coax is plugged into the 119 side (as instructed in the book), but even if I switch it, there's no difference. I even tried a second LNB, and it's giving me the same results.

My view of the sky is completely clear, and I've run "Check Switch" on every setup I've tried (Twin LNB & Dual LNB, Coax tried in both sides). No luck. I can bring in the 110 channels, but there's no sign of the 119 satellite.

Any suggestions??

[DruzeTito]

check to see if the pole is level. Btw, don't you have free pro installation from dish???

[satdish]

If you get the 110 sat on the 119 side of the lnbf it will never see the 119.Try this first take the satellite in cable off the rec.then do a check switch this will clear the switch matrix in the rec it will read xx xx .Now being that you are confident you can get the 110 sat.get a dual lnbf and put it on the 110 side of the y adapter and tune in the 110 sat once done take dual off and put dish pro twin back on and run a check switch and the 119 will be their.The only time I`ve had a problem after doing this is when power lines or telephone lines are in the path of the 119 and being the dish pro is more prone to interference all I had to do was take the dish pro twin off and put a legacy twin on and that fixed the interference problem hope this helps