http://www.sadoun.net/forums Discuss installation, features, and tech support issues on Digipower (aka Moteck) SG2100, H180 Horizon to Horizon motors. Also, Moteck actuators. en Sat, 21 Nov 2009 07:23:24 GMT vBulletin 60 http://www.sadoun.net/forums/images/misc/rss.jpg http://www.sadoun.net/forums http://www.sadoun.net/forums/moteck-digipower/17765-sg2100-not-moving-stopping-properly.html Sun, 25 Oct 2009 23:05:31 GMT Equipment: ViewSat MaxHD Digipower SG2100 Chieta 4-in-1 switch The Digipower 2100 motor will not respond promptly to commands. That is, I have to push East or West on the remote... Equipment:
ViewSat MaxHD
Digipower SG2100
Chieta 4-in-1 switch

The Digipower 2100 motor will not respond promptly to commands. That is, I have to push East or West on the remote twice in rapid succession to get it to move. Likewise, pressing Stop on the remote twice quickly is the only way to stop it. Without physically watching the dish I can't tell if it is actually moving or not, nor if it has stopped. Also, when the satellite meter is connected and I press the motor button to move the dish, it will move only west. Pressing the button twice to move east results in a start then sudden stop. The meter also goes "dead" for a couple seconds after this like it is resetting or something. This happens when the meter is between the receiver and motor, and between the LNB and motor. The dish moves both directions without the meter in the equation. It appears the motor is faulty, but I'm open to suggestions. The motor was purchased from Sadoun a little less than a year ago, I think. Thank you all for your help. ]]> Moteck Digipower Montavius http://www.sadoun.net/forums/moteck-digipower/17765-sg2100-not-moving-stopping-properly.html