Hi;
New don't know if this would be the proper forum but here goes anyway.
I have a Expressvu system with 2 LNB and using
HD, I would like ot hook it up to a JVI Trunkline 35-TRDS8, this unit was installed a few motnhs ago and removed for renovation, Now I aa m trying ot reinstall but lost the paper that I had on it.
Anyway the layout of this switch is as follow
Unit facing me.
From top left to right
Power ( easy one )
LNBA : 18VDC 22Khz
LNBA : 18VDC 0 KHz
LNBB : 13VDC 22KHz
LNBB : 13VDC 0 KHz
At the bottom from let to right
RX1 to Rx8
Now Sat as 2 LNB one as 2 x 91 and the other 2 x 82 sat feed
If i use a SW21 switch I install SAT 91 to the SAT 2 position of the SW21 and SAT 82 to SAT 1 position.
Now i tried every single configuration and I amm still unable to get this switch properly working.
If someone could help me I would appreciate
tks
I am thinking of installing only 2 receiver, I know I could use 2 SW21 but I would like to reconnect it the way it was for further infi
tks for your help
I appreciate
Bernard
Linear Mode
